DIRECTIONS:
Mop / Wet Vacuum Stripping System: Dilute
in cold or mildly warm water according to the
type of finish below: One part product to 2 parts
water for heavily built-up or highly burnished
finishes. One part product to 5 parts water for
normal build-up. Apply liberally with a mop to
an area small enough so as not to allow the product
to dry and allow to stand for 2 to 5 minutes.
Agitate with a mop and remove solution and old
finish with a wet vacuum. Allow floor to dry thoroughly
and apply new finish as directed by manufacturer.
If complete stripping is not accomplished repeat
the above procedure before re-application of new
finish.
Floor Machine Stripping System: Dilute in
cold or mildly warm water according to the type
of finish below: One part product to 10 parts
water for heavily built-up or highly burnished
finishes. One part product to 15 parts water for
normal build-up. Product may be applied with a
mop or Automatic Scrubber. Allow to stand for
3 to 5 minutes, scrub with a rotary floor machine
or automatic scrubber equipped with stripping
pads. Remove solution and old finish with a wet
vacuum and allow the floor to dry completely.
If desired, a deep rinsing step can be added.
Apply new finish per manufacturer recommendation.
NOTE: As prolonged soaking in concentrated strippers
may damage some asphalt tiles, a spot test is
recommended before general use.
| Active
Ingredients: |
55.0
± 0.5% |
Detergency: |
Excellent |
| Color: |
Clear |
Rinsability: |
Excellent |
| Odor: |
Sassafras |
Flash
Point: |
145oF
(TCC) |
| pH: |
12.5
- 13.0 |
Biodegradability: |
Complete |
| Viscosity: |
Water
thin |
Storage/Stability: |
2
years |
| Foam: |
Low |
Weight
per Gallon: |
8.27
lbs./gal. |
| Abrasives: |
None |
Freeze
/ Thaw Stability: |
Keep
from freezing |
| Phosphate
Content: |
None |
|
|
| Solubility: |
Complete
with water |
|
|
| Emulsification: |
Excellent |
|
|
|
