For
Use On:
Sealed
Wood, Sealed Cork, Sealed Concrete, Parquet
Floors.
DIRECTIONS:
On New Or Newly Prepared Floors: Use a
good quality polyurethane sealer, following
the directions for that product. Allow to
dry thoroughly.
On Newly Sealed Floors: Buff with a #120
abrasive screen. Clean surface thoroughly
with a tack rag and waterless cleaner and
allow to dry. Apply finish using a synthetic
or lamb’s wool applicator, pressure sprayer
or gravity fed applicator. If more than one
coat is desired, allow 6 to 8 hours dry time
between coats. No screening is required if
recoating is done within 24 hours. Allow 72
hours cure time before allowing any foot traffic
on floors (no dances or similar events for
at least one week).
NOTE: Best results are obtained
with adequate ventilation and floor temperature
above 60°F and below 95°F when using these janitorial supplies. Avoid direct
drafts on floor while finishing.
CAUTION:
Do not use on any resilient type flooring.
Non-volatile
solids:
|
30.0±0.5% |
Chemical
Resistance: |
Excellent
|
| Color: |
(Typical)
4
(Maximum) 12 |
Drying
Properties: |
Set
to Touch - 1-2 hours |
| Odor: |
Solvent
|
Recoat: |
6-8 hrs. Dry hard - 72 hrs. |
| Type:
|
Oil
modified urethane |
Recoatability:
|
Excellent
(follow directions) |
| Solvent
Systems: |
Mineral
spirits |
VOC
Content: |
443
gm/liter |
Flash Point: |
None
(waterbased) |
Storage/Stability:
|
2
years |
| Viscosity: |
A-C |
Freeze/Thaw
Stability: |
Keep from freezing |
Gardner
Slip Resistance: |
Greater
than 0.50 |
Weight
per Gallon: |
7.45
lbs./gal. |
| Sward
Hardness: |
Greater
than 30 |
Coverage:
|
400-500
ft2 per gal. |
